6.5" 2-way Component Speaker System
Clarus™ is the entry-level high performance speaker line from Hybrid Audio Technologies. We use the phrase "entry-level" rather loosely, as we think you'll find these speaker systems to outperform systems costing twice and three times as much. The Clarus systems contain speaker drivers and passive crossover networks that were developed and assembled with a significant effort in research and development, materials science engineering, an exhaustive level of sampling and prototyping, real-world testing, and obsessive attention to detail. In our double-blind testing of the Clarus™ C51-2 and C61-2 sets (5 1/4" component set and 6 1/2" component set, respectively), the Clarus™ was the clear-cut winner in all tonal and spectral balance categories! The Clarus™ line is a cost-effective approach to getting high-end Hybrid Audio sound in any car!
|
Frequency Response
|
C61-2:
50 Hz – 22,000 Hz, ± 3 dB
Typically, in-car response including
vehicular “cabin gain”, or the gain expected with midbass installed in
the vehicle, will result in an extended midbass and upper subbass
response. This is a result of these frequencies being below the lowest
resonance in the vehicle (typically around 50-125 Hz in most vehicles. In
more practical terms, install the Clarus midbass into your vehicle and you
will see a dramatic improvement in midbass and upper subbass output, much
more so than just simply listening to the Clarus in a large room.
|
|
Efficiency and 1 watt/ 1 meter
|
C61-2:
90 dB
|
|
Continuous Power Handling (RMS)
|
C61-2:
100 watts (musical input)
|
|
Peak Power Handling
|
C61-2:
250 watts (musical input)
|
|
Recommended Power Range
|
C61-2:
25 – 175 watts (musical input)
|
|
Nominal Impedance
|
4 ohms
|
|
Abbreviated Thiele/Small Parameter Discussion for Clarus
C6 Midbass Speakers
|
The mechanical and electrical
parameters of the Clarus C6 midbass are amenable to a variety of different
installations and speaker locations. The high Qms (Q factor of mechanical
system) and Qts (Q factor of total system), coupled with the driver’s Fs
(resonance frequency) allow it to be used in an “infinite baffle”
configuration. In more practical terms, install the Clarus midbass such
that the front and back waves don’t “meet”, including in a door or
kick panel (using only the airspace behind the speaker as a pseudo
enclosure), with no need for a real enclosure or “box.” The design
goes hand in hand with fool-proof, high-end sound quality with minimal
work.
|
Includes:
2- Clarus™ Midrange speakers
2- Clarus™ Tweeters with surface, flush and angle mounts
2- Clarus™ Passive crossover networks
2- Speaker grilles and mounting hardware
 Clarus™ Users Manual
|
 |
| Manufacturer |
Hybrid Audio Technologies |
| Unit |
|
| SKU |
C61-2 |
|
E-mail a friend about this item.
|
